User Manual

the Petcube Play icon on the next step for about 10-15 seconds until it takes
you to the next step (make sure you don’t move your finger while you’re
holding it down).
Now, slide left to step 2 in the Petcube app and make sure the light on
the camera blinking green. Slide left again to step 3 in the Petcube app
and press ‘Connect to Petcube network’.
Wait for the app to exchange data with the Petcube Camera and scan
for available Wi-Fi networks, then select your home Wi-Fi network from
the list, put in your network password and hit ‘Connect’. If you don’t see your
home network on the list or if you’re using a hidden network, connect to your
home Wi-Fi by pressing ‘Connect manually’, then enter your network name
and password and hit ‘Connect’ (keep in mind that it is case sensitive).
Once the LED light on your Petcube Camera changes to solid white, you are
ready to play with your Petcube Camera.
6. Oh bummer setup error
If during the setup you’re getting an ‘Oh Bummer’ error message, turn your
Petcube off and back on, wait up to 1 minute until it boots up and starts blinking
and start the setup process over again.
7. I don’t see my home Wi-Fi network
This problem can occur if you are trying to connect your Petcube to either
a 5GHz frequency range network or a hidden network.
Unfortunately, Petcube doesn’t work with 5GHz networks, but since most routers
support both 5GHz and 2.4GHz frequencies at the same time, you should not