User Manual

18
6. Where to place your Petcube Bites
Consider placing Petcube Bites in a location that allows for maximum coverage through
the camera’s 160° wide angle lens. It’s always a good idea to point the Petcube Bites
in the direction where your pets tend to spend most of their time.
If you want to place Petcube Bites on a table or shelf, we recommend you set it up
at least 3 feet above the floor. Petcube Bites has a non-slip rubber bottom, which
provides a secure grip on flat surfaces. The camera should be placed closer to the edge
of the surface for better viewing angle.
If you decide to mount Petcube Bites securely on the wall, select your preferred viewing
height. Then, use the included mounting guide to mark where to drill holes and two
drywall anchor screws to affix the device.
7. Treat recommendations
• Treats should be uniform in size (ideally spherical), no smaller than 0.3 inches
and no larger than 1 inch in length. The treat hopper can fit up to 2 lbs of treats.
• Treats must be dry and hard
• Treats should not be greasy, soft, sticky or crumbly
• Use treats that are all the same size and shape
• For smaller size treats, multiple treats may be dispensed at once
Close the container lid for an airtight seal to keep treats fresh and so no odors get out.
8. Cleaning made simple
The detachable treat container is dishwasher safe on lower temperature/delicate
cleaning settings (up to 130’F), or you can wash it by hand.To detach the treat container,
push the back release button to the right and pull up and away from the base.