User's Manual

Mote Model 3
User Manual
18
3-3. Confirm a successful power-up
On the opposite side of the battery compartment, you will notice a flashing red LED on the top-
right corner of the Mote, indicating that the Mote was successfully powered up and ready to
receive WiFi credentials. If no light appears; remove the battery, wait 15 seconds and reinsert the
battery.
Step 4: Initiate Blink Up
4-1. Select Start on your mobile device
After selecting Start, there will be a 3-second countdown on-screen before Blink-Up starts. You will
need to quickly perform the next step before the countdown ends.
4-2. Place the Mote (LED side) on the screen of your mobile device
With your mobile device on a table or in your palm, place the Mote on top with the blinking red
LED facing the screen. If the Blink Up sequence starts before you place the Mote on the screen,
wait until the sequence is over, select the back arrow and try again.
4-3. Confirm a successful Blink Up
As soon as the Blink Up sequence is over, pick up the Mote and check the LED. You should
immediately see a flashing green LED, indicating that the Mote successfully received your WiFi
credentials.
Step 5: Confirm a successful WiFi connection
5-1. Confirm a recent measurement on the Petasense App
To confirm that the mote has taken a measurement select the Sensors option at the bottom of
your screen. Then select the Sort option at the top left of the screen. From there select Serial
Number - Ascending/Descending. Find the serial number of the mote you are attempting to
connect and verify that a measurement has been taken by checking the Last Measurement option.
5-2. Reassemble the Mote