Installation Guide

8. Complete the rear of the kennel with the addition

of four horizontal rails (D) and an intermediate post (C).

Tighten all screws in all connectors.

Note: If you are building in 5 ft. x 15 ft., only two

horizontal rails are needed to complete.

ASSEMBLY INSTRUCTIONS

9. With two people, lift the chain link fabric roll (A)

up into a standing position and drop a tension rod (G)

into the end links and connect to the gate post (F) with

five gate clips (BB) evenly spaced. Unroll the fabric

around the kennel frame.

Use wire ties (AA) to secure fabric to the top of the

kennel frame (D) to keep it in place. Ties can be

loosely applied and then tightened after the fabric is

fully unrolled.

10. To insure the tightest fit of the fabric, it

is suggested to pull the fabric as tight as possible

at each vertical member and apply three wire clips

(CC) to hold in place as one person is tensioning

the fabric.

Doing this as the fabric is unrolled, at all 7 of the

vertical members will assist in making the final

length determination and a tight fit of the chain link

fabric.