Installation Guide

ASSEMBLY INSTRUCTIONS

5. Working toward the right, slide another set of

horizontal rails (D) into the intermediate post (C)

and then a corner post (B) to the right.

NOTE: Adjust your use of corner posts (B) and

intermediate posts (C) depending on which

configuration you are building, following the

exploded view shown earlier.

7. Insert top and bottom horizontal rails (D) into the

corner posts to start the side of kennel, then into

an intermediate post (C). Then, another set of

horizontal rails (D) and then a corner post (B).

This will complete the right side of the kennel frame.

Note: If you are building in the 5 ft. x 15 ft.

configuration, repeat the process with two more

horizontal rails and another intermediate post.

Repeat this process to complete the left side of

the kennel.

Tighten the screws on all corner (B&H), gate (F) and

intermediate posts (C). It is important to leave 2 inches

space between the swinging side of gate and the post

for proper latch function. This will complete the gate

side. Carefully stand the completed panel up.

2 in.