Installation Guide

ASSEMBLY INSTRUCTIONS

3. Lay the assembled gate on the ground and slide

horizontal rails (D) through the tubes on the

gate post (F).

Note: Bottom of posts have 1 in. extension.

4. Slide the top and bottom horizontal rails into corner

post (H) and then slide on an intermediate post (C)

on right.

Note: If you are building a 5 ft. x 15 ft. then you will

use a corner post (B) at the right end of the

horizontal rails (D).

2. Assemble gate (E) and gate post (F). Start by

removing the gate keeper screw from the top hinge

tube on the gate post (F). Insert the top of the gate

into the hinge tube and push in as far as it can go.

Then, guide the bottom of the gate onto the bottom

hinge tube. Push gate back downward to sit on the

bottom hinge tube. Re-install the gate keeper screw

to capture the gate.

Note: The gate post (F) is designed to allow the

horizontal rails (D) to slide through the tubes.