Installation Guide

SAFETY INFORMATION
HARDWARE CONTENTS
3
PREPARATION
Please read and understand this entire manual before attempting to assemble, operate or install
the product.
Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list and hardware contents list. If any part is missing or damaged, do not attempt to
assemble the product. This kennel can be built in two configurations: 10 ft. x 10 ft. or 5 ft. x 15 ft.
Estimated Assembly Time: 2 Hours
Two people are recommended to assemble this kennel.
Tools Required for Assembly (not included): #2 Phillips Screwdriver, 9/16 in. Wrench, Pliers
Choose the site for your kennel. The location should be flat, level and suitable for pets. Choose
location of door before you start to build kennel.
ASSEMBLY INSTRUCTIONS
1. Gather the corner and intermediate posts (B & C) and
gate post (F). Each post is labeled with a removable
sticker as the bottom of the post, for easy
identification. Loosen the pre-assembled screws in
the connectors to make insertion of horizontal rails
(D) possible. Do not remove screws, just loosen.
Note: Bottom of posts have 1 in. extension.
Pro Tip: For ease of assembly, we suggest you
lay the posts and rails out on the ground in a
manner that corresponds to the exploded view of
your chosen configuration, either Fig. 1 (10’ x 10’)
or Fig. 2 (5’ x 15’).
1
B
C
F
H
See Label on Posts
Steel
Wire Tie
Qty. 80
Gate Clips
Qty. 10
Steel Wire Clips
Qty. 22
AA BB
CC