ITEM #0476087 CHAIN LINK PET KENNEL MODEL #830063 5 ft. x 15 ft. x 6 ft. Configuration 10 ft. x 10 ft. x 6 ft. Configuration ATTACH YOUR RECEIPT HERE Purchase Date Questions, problems, missing parts? Before returning to your retailer, call our customer service department at 1-800-576-2367, 8 a.m. - 6 p.m., EST, Monday - Friday. Reach us by email at PetSentinel@opbglobal.
PACKAGE CONTENTS D Fig. 1 10 ft. x 10 ft. x 6 ft. Configuration D D D B C A C D D C D D C B B D D D F H D D D D G E 5 ft. x 15 ft. x 6 ft. Configuration D Fig.
HARDWARE CONTENTS AA Steel Wire Tie Qty. 80 BB CC Steel Wire Clips Qty. 22 Gate Clips Qty. 10 SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble, operate or install the product. PREPARATION Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware contents list. If any part is missing or damaged, do not attempt to assemble the product. This kennel can be built in two configurations: 10 ft.
ASSEMBLY INSTRUCTIONS 2. Assemble gate (E) and gate post (F). Start by removing the gate keeper screw from the top hinge tube on the gate post (F). Insert the top of the gate into the hinge tube and push in as far as it can go. Then, guide the bottom of the gate onto the bottom hinge tube. Push gate back downward to sit on the bottom hinge tube. Re-install the gate keeper screw to capture the gate. Note: The gate post (F) is designed to allow the horizontal rails (D) to slide through the tubes. 3.
ASSEMBLY INSTRUCTIONS 5. Working toward the right, slide another set of horizontal rails (D) into the intermediate post (C) and then a corner post (B) to the right. 5 DD B D NOTE: Adjust your use of corner posts (B) and intermediate posts (C) depending on which configuration you are building, following the exploded view shown earlier. D B D C C D 6. Tighten the screws on all corner (B&H), gate (F) and intermediate posts (C).
ASSEMBLY INSTRUCTIONS 8. Complete the rear of the kennel with the addition of four horizontal rails (D) and an intermediate post (C). Tighten all screws in all connectors. Note: If you are building in 5 ft. x 15 ft., only two horizontal rails are needed to complete. 8 D D B B B C D D 9. With two people, lift the chain link fabric roll (A) up into a standing position and drop a tension rod (G) into the end links and connect to the gate post (F) with five gate clips (BB) evenly spaced.
ASSEMBLY INSTRUCTIONS 11. Chain link fabric (A) is cut to size but may need to be shortened for exact fit. You may need to “cut” the fabric by removing a wire. When the fabric is fully unrolled and the ties have secured the fabric to the vertical members for tightness, you should assess the remaining length and whether the fabric will need to be shortened.
WARRANTY ONE YEAR LIMITED WIRE KENNEL WARRANTY What is Covered The manufacturer warrants that the kennel will be free from defects in workmanship for a period of one (1) year. This warranty is extended only to an original purchaser who installed the product at a residence (not commercial premises) in the 50 United States. It is not transferable. If a defect exists, the manufacturer will, at its option, either repair or replace the product or the defective component.
