Installation & Assembly

ManualsBrandsPet Gear ManualsDogEasy Steps II Extra Wide 2 Step Pet Stair

To see our full line of products, visit us online at: www.petgearinc.com

CUSTOMER SERVICE HELP DESK

customerservice@petgearinc.com

Toll-Free 877-752-9123 - Eastern Standard Time 8am-3pm, Monday through Friday

For The ON-THE-GO Pet

™

INSTRUCTION MANUAL

EASY STEP II EXTRA WIDE

PG9720XLCH/PG9720XLTN

Summary of content (5 pages)

PAGE 1
For The ON-THE-GO Pet™ INSTRUCTION MANUAL EASY STEP II EXTRA WIDE PG9720XLCH/PG9720XLTN To see our full line of products, visit us online at: www.petgearinc.com CUSTOMER SERVICE HELP DESK customerservice@petgearinc.
PAGE 2
PARTS LIST Check that you have all the parts shown BEFORE assembling your product. If any parts are missing, call Customer Service.
PAGE 3
ASSEMBLY INSTRUCTIONS Step 1 Place right panel, part (B) on floor with PET GEAR Logo facing the floor and insert top stair, part (E). Keep the STRAIGHT EDGE toward the back and rug facing the top. Make sure there are no gaps between parts after inserting. (If inserting part is difficult put a little dish soap on doweled end before inserting.) E B C Step 2 Insert riser, part (C). Make sure there are no gaps between parts after inserting. Step 3 Insert bottom stair, part (F).
PAGE 4
ASSEMBLY INSTRUCTIONS Step 5 Insert center support panel, part (G), in middle row of holes. Make sure there are no gaps between parts after inserting. G Center Row of Holes Insert Dowel Step 6 Insert dowel, part (D), into hole and slide into notch on center support panel.
PAGE 5
ASSEMBLY INSTRUCTIONS Step 7 Attach left panel, part (A). Align all holes before pushing panel down. A Make sure there are no gaps between parts after inserting. WARNING! FOR PETS ONLY. Not intended to be used as a restraining device for aggressive or dangerous animals that dig, chew or paw aggressively. Do not leave your pet unattended. PET GEAR is not liable for any damage caused by aggressive, destructive, immature or untrained animals. Do not use near an open or exposed flame.