For The ON-THE-GO Pet™ INSTRUCTION MANUAL NO-ZIP EXCURSION PET STROLLER PG8650NZ Interior Dimensions: 26"L x 15"W x 20"H To see our full line of products, visit us online at: www.petgearinc.com CUSTOMER SERVICE HELP DESK customerservice@petgearinc.
PARTS LIST Check that you have all the parts shown BEFORE assembling your product. If any parts are missing, call Customer Service.
BACK WHEEL ASSEMBLY Step 1. Hold down lock release button shown A. in Figure A and slide back wheel into axle shown in Figure B. Lock/Release Button Lock When the wheel meets the stroller, let go of the lock release. B. Step 2. Pull on wheel to make sure the wheel is engaged. Repeat on other side. When finished it should look like Figure C. C. A. Outside Inside To Remove Back Wheels : Hold down the lock/release button (Figure A) and pull wheel off.
FRONT WHEEL ASSEMBLY Step 1. To attach front wheel, hold down on the wheel release button as shown in Figure D. ele Wheel Release Button D. Step 2. While holding down the wheel release button, insert the metal post on the wheel and push down until the wheel meets the stroller (Figure E.) Let go of the wheel release. Pull up slightly on wheel to be sure it’s locked in place. Repeat for other front wheel. E. Stroller with wheels assembled.
STROLLER ASSEMBLY As you unfold the stroller, straighten the side latches until they lock in place shown in Figures G and H. You will hear a click when the slide latches are engaged. G. H. To adjust handlebar, push in buttons located on each side of the handlebar and adjust to comfort shown in Figure I. I.
STROLLER ASSEMBLY To open the front canopy on your stroller, simply push the release button located on the front of your stroller and lift the canopy shown in Figures J and K. To close the front of your stroller, clip the canopy back into the front of the stroller. J. K. Release elease Button To open the back of your stroller, simply push the release button located on the back of your stroller and open the rear door shown in Figures L and M.
FRONT WHEEL LOCKING INSTRUCTIONS Step 1. To use stroller in locked position for jogging, push wheel lock down shown in Figure N. N. Step 2. To use stroller in swivel position, push wheel lock up, shown in Figure O. O. Wheel Lock ck TO ASSEMBLE BACK TRAY Step 1. To assemble the back tray, align the holes on the front of the tray with both of the knobs on the stroller, and secure into place by pushing forward, then down.
TO FOLD/PACK UP STROLLER Step 1. Fold down handlebar by pushing in the buttons Step 2. Pull up on the hooked part of the side latch (Figlocated on each end of the handlebar shown in Figure P. ure Q.) until latch disengages. Q. P. TO FOLD/PACK UP STROLLER Step 3. Fold sides inward and push forward shown in Figure R. R.
LOOKING AFTER YOUR STROLLER • • • • • • Always store product in a clean, dry place. Not recommended for use on the beach. Do not put heavy items on top of the stroller. Clean frame by wiping with a lightly oiled cloth. Do not use detergent or abrasives. Spot clean fabric with dry cleaning fluid or mild soap and warm water. To ensure easy maneuverability and to minimize wear and tear, (especially wheels, axles, and swivels), keep all moving parts clean and lubricated with WD40® or light machine oil.
WARNING! FOR PETS ONLY. Not intended to be used as a restraining device for aggressive or dangerous animals that dig, chew or paw aggressively. Do not leave your pet unattended. PET GEAR is not liable for any damage caused by aggressive, destructive, immature or untrained animals. Do not use near an open or exposed flame. Failure to follow these warnings and the instructions could result in serious injury or death.
