Operations Guide

9
2 Installing the DAS RFID 9200 System
The following figures (Figures 2 and 3) illustrate the I/O ports, including antenna
ports, located on the RFID DAS 9200 Reader. Antenna ports and LED status indicators
are located on the front panel of the Reader while power, Ethernet and USB interfaces
are located on the back panel of the Reader. An illuminated Green light on Power
indicates that the Reader is powered. An illuminated Green LED light on any RF port
(ie. RF 1 – RF 8) means that that port is active. An illuminated Green light on Read
implies that the Reader is successfully detecting tags while an illuminated Green light
on CRC implies that there is a CRC error over a tag read.
Under normal operation, the LEDs of the active ports will flicker indicating activity
on the ports and the read LED will flicker as tags are read while the reader is reading.
Corresponding antenna status LED Successful tag read status LED CRC status LED
Power status LED
Antenna1 Antenna 2 Antenna 3 Antenna 4 Antenna5 Antenna 6 Antenna 7 Antenna 8
Figure 2: DAS RFID Antenna Ports and Status LEDs
+24VDC power 10/100 base-T Ethernet USB Embedded PC for debugging (for PervasID use)
Figure 3: RFID DAS Port Connections
The USB Embedded PC interface labelled Host on Figure 3 gives access to the
embedded WinCE PC and may be used to configure the reader IP address. Please
contact PervasID should you require access to this interface.