Operations Guide

2
Federal Communications Commission (FCC) / IC Canada Compliance Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B device
under Part 15 of the FCC regulations. The limits are designed to provide protection
against harmful interference in a commercial environment. This equipment is designed to
intentionally radiate RF energy and if not installed correctly in accordance with
instruction, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in any given installation. If this equipment
does cause interference which can be determined by turning the equipment on and off,
the interference may be reduced by:
Increasing the separation between the equipment and the receiver
Reorient or relocating the equipment antenna.
Only the recommended antennas listed in Appendix A should be used with this
equipment and the output power should be set depending on the cable length in
accordance with the PervasID Power tool. (see section on antenna connection)
This equipment complies with FCC/IC radiation exposure limits set forth for an
uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines
in Supplement C to OET65 and RSS-102 of the IC radio frequency (RF) Exposure rules.
This equipment should be installed and operated so that the antennas are kept at least 7.9
inches (20 cm) or more away from a person’s body (excluding extremities: hands, wrists,
feet and
ankles).
ETSI Compliance
The RFID DAS 9200 Reader (the Reader) is a product and has been certified to IEC 60950-
1/EN 60950-1 and EN 301 489-1/EN 301 489-3.
Warning: Please read this manual in its entirety before operating the RFID DAS 9200
Reader, as personal injury or equipment damage may result from improper use.
Under no circumstances should the RFID DAS 9200 enclosure be opened.
Caution: Risk of explosion if lithium battery (Model Number: CR 1216; located inside
the RFID DAS 9200 reader) is replaced by an incorrect type. Dispose of used batteries
according to the instructions.
Caution: Only the power supply unit (PSU) (Model number: AEB70US24 or
AEB100PS24; XP POWER - AC-DC converter, EXTERNAL PLUG IN), supplied with
the RFID DAS 9200 reader can used for powering the RFID DAS 9200 reader. Any