Operations Guide

11
Figure 4: Example antenna placements over an interrogation area
Other read and antenna configurations are outlined in the PervasID installation
guide.
3. Connect the Reader to the network
You are now ready to connect the installed RFID DAS 9200 to your network.
You should connect the Reader directly to your Ethernet network. Once the Reader is
powered, it will communicate with a hosted server.
Make sure that there is no firewall in place which might prevent the Reader
communicating with the hosted server. You must be able to communicate with the
server (93.93.128.16) over the port assigned for your trial (default port 9200) and NTP
on port 123. The reader is configured be default to a static IP address in the
192.168.14.X subnet.
4. Connect power to the Reader
You should connect the 24VDC external universal power supply into a suitable power
outlet.