8 acd el) Instructions for Use A Warning! Fully charge the power station before first use. Power ON Press any button to tum ON the power station. The display screen will light up to indicate the power station is on. Power OFF--With all outputs OFF the power station will enter standby mode after 30 seconds. The display will dim. Operation The display screen will indicate if an output is On or Off. s Press the AC button to tum ON or OFF the AC outputs. = Press the DC bunion to urn ON or OFF the DC outputs.
OPERATION GREEN LED BLINKING: NO LESS ON, NO BEEPING: Vehicle battery is low. Vehicles battery may be damaged. Press the "BOOST" button Confirm the clamps are connected on the cable. Wait for the correctly. Next, press the "BOOST" GREEN LED to turn solid. button on the cable. Wait for the When solid, start vehicle GREEN LED to tum solid. within 30 seconds. When solid, start vehicle within 4. Start the vehicle. 30 seconds. 5. After the vehicle starts, removes the jumper cable clamps from the vehicle battery.
Connecting a back-up battery (if equipped} This power station can be connected to a back-up battery {if equipped), expanding the capacity. The power station and the back-up battery can be connected with a cable. When charging, the power station battery will be charged first. The back-up battery will be charged after the power station battery has been fully charged.
TROUBLE SHOOTING connected to the station outputs are not receiving power. Problem Analysis Solution The charger is not completely connected to | Completely connect the the unit. The charge indicator light is off. charger to the power station. The product cannot be charged. Charger is connected correctly, but the Charger is damaged, contact charge indicator light is off. the customer service. indicator light on,but still cannot charge. The unit ls damaged.
