Users Manual Part 2

NO NDA REQUIRED

The export and/or the release of certain products, technology and software to non-US persons might

be subject to export restrictions. Please refer to the US export laws & regulations for details.

03EN073 Rev. M

PAGE 149 OF 176

Operations outside of the FCC grant will require special licensing.

Approved Antennas:

The radio transmitters listed in the table below have been approved by the FCC to operate with

the antenna types listed below with the maximum permissible gain indicated. Antenna types not

included in this list, having a gain greater than the maximum gain indicated for that type, are strictly

prohibited for use with this device.

Part Number FCC ID Antenna Type Max. Gain Approved (dBi)

RF-2100 2AG3J-RF2100 Omni 7.4

RF-5100 2AG3J-RF5100 Omni 3.5

RF-2150 2AG3J-RF2150 Omni 8.5

EIRP (Isotropic Radiated Power) = Power Setting + Antenna Gain - Cable Loss

National regulations may require that operations may be limited to portions of the frequency range

shown in the channel selection page of the interface.

PROFESSIONAL INSTALLER – COMPLIANCE

Radios operated in a portable conﬁguration can be attached to dismount users using a holster via

a MOLLE attachment method. As required by ANSI C95.1 Speciﬁc Absorption Rate, all portable

conﬁgurations, using 2.15dBi antennas, are required to maintain a separation distance of 5cm from

the body.