Users Manual Part 2

NO NDA REQUIRED

PAGE 142 OF 176

The export and/or the release of certain products, technology and software to non-US persons might

be subject to export restrictions. Please refer to the US export laws & regulations for details.

03EN073 Rev. M

PROFESSIONAL INSTALLER – COMPLIANCE

NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY

UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S

AUTHORITY TO OPERATE THE EQUIPMENT.

NOTE II: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in

a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following measures:

▶ Reorient or relocate the receiving antenna.

▶ Increase the separation between the equipment and receiver.

▶ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

▶ Consult the dealer or an experienced radio/TV technician for help.

OPERATING FREQUENCY: Operating frequency is determined by the installer. It is important that the frequency

conﬁgured meets local regulations.

NOTE III: Please note that if the FCC identiﬁcation number is not visible when the module is installed inside another

device, then the outside of the device into which the module is installed must also display a label referring to the

enclosed module. This exterior label can use wording such as the following: “Contains FCC ID: XXX” where XXX =

the radio module’s FCC ID. Any similar wording that expresses the same meaning may be used.