Manualshelf

Users Manual Part 2

ManualsBrandsPersistent systems ManualsElectronicsS-Band Interchangeable Frequency Module
21222324252627282930
© 2010 - 2020 Persistent Systems, LLC – All Rights Reserved
NO NDA REQUIRED
The export and/or the release of certain products, technology and software to non-US persons might
be subject to export restrictions. Please refer to the US export laws & regulations for details.
03EN073 Rev. M
PAGE 79 OF 176
USING THE WEB MANAGEMENT INTERFACE: INDIVIDUAL NODE INFO
4
Configure settings if needed.
Note: changing these settings may cause poor performance or loss of connectivity.
Radio Name: Assign a name - check the Factory Default box to use the factory default name.
Frequency: Assign a frequency to operate on. Nodes must be operating on the same frequency to communicate. Ensure
that the frequency is set to match the RF module installed in the unit.
Bandwidth: Assign a bandwidth to operate on. Nodes must be set to the same bandwidth to communicate. Band-
width should be increased for shorter distances and decreased for longer distances.
Max Link Distance: Set Max Link Distance to the maximum distance any individual link between nodes in the network
may need to be. All nodes on the network must be set to the same Max Link Distance.
Channel Density: Select the menu item that corresponds to the number of nodes in the network.
Radio Preference: Increasing radio preference will make the routing protocol more likely to choose this node when
routing traffic in the network.
Max Transmit Power/Chain: Adjust transmit power of the node - this setting is per chain. The total power is shown to
the right of the drop down menu.
Transmit Chain Select: Choose which RF chains to use to transmit - you may select one, two, or three chains. The Auto
setting will instruct the MPU5 to select Transmit Chains on its own.
Receive Chain Select: Choose which RF chains to use to receive - you may select one, two, or three chains. The Auto
setting will instruct the MPU5 to select Receive Chains on its own.
5
Scroll to the bottom of the page and click Save & Reconfigure Unit.
!
WARNING!: User MUST refer to the Professional Installer – Compliance Section of this manual for approved
power levels and approved channels. This warning applies only to RF-2100 with the FCC ID 2AG3J-RF2100, RF-5100
with the FCC ID 2AG3J-RF5100, and RF-2150 with the FCC ID 2AG3J-RF2150.
!
WARNING!: User MUST refer to the Professional Installer – Compliance Section of this manual for approved
power levels and approved channels. This warning applies only to RF-2100 with the FCC ID 2AG3J-RF2100, RF-5100
with the FCC ID 2AG3J-RF5100, and RF-2150 with the FCC ID FCC ID 2AG3J-RF2150.