Operator's Manual
© 2010 - 2020 Persistent Systems, LLC – All Rights Reserved
NO NDA REQUIRED
PAGE 24 OF 176
The export and/or the release of certain products, technology and software to non-US persons might
be subject to export restrictions. Please refer to the US export laws & regulations for details.
03EN073 Rev. M
PHYSICAL SETUP: RF SETUP TROUBLESHOOTING
How do I ensure that the RF
module is aligned properly?
?
The three RF connectors on the RF module will align
with the three RF connectors on the chassis. When
aligned properly, the engraved writing on the RF
module will be facing the same direction as the
writing on the chassis.
What do I do if the RF module
won’t insert into the chassis?
?
Ensure that the RF module is aligned properly.
Ensure that the connectors on the RF module are
not bent.
Ensure that there are no foreign objects in any of
the connectors, on the bottom of the RF module, or
in the chassis well.
1
2
3
What do I do if the antennas won’t
screw onto the RF connectors?
?
Ensure that you are using antennas with RP-TNC
Male connectors or an appropriate adapter from
your TPI kit.
Ensure that the connectors on both the unit and
antennas are not damaged.
Ensure that there are no foreign objects in any of
the connectors.
1
2
3
How do I tell if the antennas are
connected properly?
?
When an antenna is mated properly, the threads on
the connector will not be visible. However, there
may be a small space between the antenna and the
chassis.
1