Installation Sheet

Congratulations on the purchase of your Perrin & Rowe Bathroom Product. Correctly installed and with sensible care, this
product will give you many years of trouble free service.
The Transitional Bathroom Collection
Installation & User Guide
IMPORTANT INFORMATION
Before you proceed... We recommend you engage the services of a registered plumber to install this
product.
For ease of possible future servicing, we also recommend the fitting of conveniently placed isolating valves.
In addition to the guide below it is essential that the written information overleaf is carefully read and
understood.
Preparation Check Box for Installer
Flush the plumbing system before
installing the bathroom product.
Once unpacked remove large & small base seals,
rosette, hood & lever, washer, backnut and banjo
connection ready for installation.
1
Place backnut onto shank and tighten to underside of worksurface.
Fit banjo connection onto shank, taking care not to overtighten.
Ensure all connections are firmly tightened
3
Please Note: Ceramic disc valves are fitted
as standard to this mixer. Flow from FULLY OFF
to FULLY ON is achieved by rotating the
handles a quarter turn.
2
BEFORE USE
• Carefully check the installation for leaks.
• If further building work is to be carried out in the vicinity, cover the tap with a plastic bag to avoid damaging
t
he finish.
• Please ensure that the installation complies with local plumbing codes.
4
Sidevalve to be installed from underside of work surface
as shown.
Leave backnut at the bottom of valve body and place
the valve body up through the work surface hole.
Assemble Top Nut with small base seal and secure down
on work surface. Then assemble hood & lever onto the
valve body ensuring that it is aligned properly. If it is not,
remove and turn a few splines until correct alignment is
achieved.
Once fully tightened screw backnut up to the underneath
of the work surface.
Connect flexible hose to the valve body and banjo
connection as shown.
Repeat this procedure for the second side valve.
The supplied extension hose is to be fitted to the
banjo as shown in the diagram.
This extension hose enables the handshower hose
to be pulled up through the handshower socket for
ease of future servicing.
Ensure all connections are firmly tightened.
Assemble handshower socket.
as shown.
Place handshower hose
through the socket, nut end first,
to leave tapered end showing.
Assemble the two tapered
bushes (larger internal diameter
to top) then push into socket.
Secure rosette onto socket.
Assemble handshower to
flexible hose.
Fit nut end of handshower hose
to the end of fitted extension
hose.
Spout
Large Base
Seal
Base Ring
Washer
Backnut
Banjo
Connection
Shank
Small Base
Seal
Vernier Insert
Washer
Backnut
Valve Body
Flexible Hose
Banjo
Connection
Washer
Nut
Banjo
Handshower
Rosette
Tapered Bushes
Base Seal
Washer
Backnut
Socket
CARE & MAINTENANCE
Wipe down after use to avoid water spotting and mineral build up.
Occasional cleaning with warm soapy water, followed by a polish with a soft cloth is all that is required to keep the
plated finish in good condition.
Do not use proprietary abrasive liquids, powders, or pads to clean the shower. Do not use any products with
ammonia bleach or limescale remover. You will damage the plated finish and void your guarantee.
Flexible Extension
Hose
WOR K SURFA CE
WORK SURFACE
Top Nut
Rosette
Hood & Lever
WORK SU RF ACE
WORK SURFACE