Installation Sheet

The Transitional Bathroom Collection
Installation & User Guide
Congratulations on the purchase of your Perrin & Rowe bathroom product. Correctly installed and with sensible care, this
product will give you many years of trouble free service.
IMPORTANT INFORMATION
Before you proceed... We recommend you engage the services of a registered plumber to install this product.
In addition to the guide below it is essential that the written information overleaf is carefully read and
understood.
Flush the plumbing system before installation.
BEFORE USE
• Carefully check the installation for leaks.
• If further building work is to be carried out in the vicinity, cover the tap with a plastic bag to avoid damaging the finish.
• Please ensure that the installation complies with the local plumbing codes.
OPEN
CLOSED
No
Groove
CARE & MAINTENANCE
• Occasional cleaning with warm soapy water, followed by a polish with a soft cloth is all that is required to keep the plated finish in good
condition.
• I
f you wish to occasionally polish your tap and it has a Chrome, Nickel or Pewter finish, we recommend a gengle metal cleaner such as
AUT
OSOL metal polish, which is available from hardware and automotive parts stores.
•
Do not use any cleaners on Gold or English Bronze taps.
• Do not use proprietary abrasive liquids, powders, or pads to clean the product. You will damage the plated finish and void
y
our warranty.
OPERATION
• This tap is fitted with quarter-turn
ceramic disc valve units. Water
flow from off to fully on is achieved
by rotating the handles a
quarter-turn.
• Ceramic disc valves are available
opening in a clockwise or
anti-clockwise direction. Should
the handle of an installed tap
operate in the wrong direction,
this can be remedied by
changing the ceramic disc valve
to the other version.
Groove
LEFT
VALVE
RIGHT
VALVE
• Follow placement dimensions supplied for
installation.
• When installing products make sure allowance
is made for tiles etc.
• Cavity should be sufficent to allow for
servicing of valves.
• Screw 1/2"NPT spout onto suitable shank
using thread sealing materials sparingly.
• Push rosette back to wall surface.
Concealed Wall Valve
Ensure the handle is vertical when the valve is in
the 'off' position.
• Assemble trim to rough ensuring handle is
aligned correctly. If it is not, remove and turn
a few splines until correct alignment can be
achieved.
1
O
1/2"
Hole
1/2"
NPT
Rough
1 /2" NPT
2MIN 1/8"
MAX 2 3/4"
3 "
1
O
3/4"
1
O
1/2"
Hole
1
O
1/2"
Hole
1 O 1/2"
Hole
1
O
1/2"
Hole
3/4"
NPT
1 1/4" MAX WALL
THICKNESS
Rough
CLOSED
• U.3320•U.3321LS •U.3322X
WALL LAV SETS
3"
1 O 3/4"
2MIN 3/8"
MAX 3 1/8"
• Follow placement dimensions supplied for
ins
tallation.
• When installing products make sure allowance
is made for tiles etc.
• Cavity should be sufficent to allow for
servicing of valves.
• Screw 3/4"NPT spout onto suitable shank
us
ing thread sealing materials sparingly.
• Push rosette back to wall surface.
• U.3330•U.3331LS •U.3332X
WALL TUB SETS
Special Note for Installing a Pair of Lever Wall Valves
OPEN
Concealed Wall Valve
Ensure the handle is vertical when the valve is in
the 'off' position.
• Assemble trim to rough ensuring handle is
aligned correctly. If it is not, remove and turn
a few splines until correct alignment can be
achieved.
3/4" NPT