Specification Sheet
Technical Data Sheet the Right Stuff Grey
Permatex, Right Stuff and Fast Orange are trademarks of Illinois Tool Works, Inc. © ITW Permatex, Inc. 2007 All rights reserved
remove the cured product from the tip.
2. Remove uncured product from parts and hand-tools with
a dry cloth, if skinned over, break film with a dry cloth to
remove as much as possible, and remove the remaining
material with Permatex
Gasket Remover as previously
stated.
3.
Clean hands with a dry cloth or Permatex
Fast
Orange
hand cleaner.
TYPICAL CURING PERFORMANCE
Cure Time
The surface of this adhesive becomes dry to touch on
exposure to atmospheric moisture within 5 minutes at 23±
2°C, 50 ± 5% RH. The product cures on exposure to moisture
in the air and dries tack free in two hours, with full cure in 24
hours. Cure times will vary with temperature, humidity and
gap.
Instant Seal
Parts assembled with Permatex
®
The Right Stuff for Imports
are instantly sealed and can be immediately placed into
service.
TYPICAL PROPERTIES OF CURED MATERIAL
Typical Value
Hardness, Shore A, ASTM D2240 60
Elongation at break, %, ASTM D412 175
Tensile strength, N/mm
2
, ASTM D412 3.4 min
TYPICAL ENVIRONMENTAL RESISTANCE
Temperature Resistance
Typical Values
Continuous, °C (°F)
-60 to 232 (-75 to 450)
Intermittent, °C (°F)
-60 to 260 (-75 to 500)
Chemical / Solvent Resistance
The product retains effective properties in contact with
automotive fluids, such as motor oil, transmission fluids,
alcohol and antifreeze solutions. Note: Not recommended for
parts in contact with gasoline.
GENERAL INFORMATION
This product is not recommended for use in pure oxygen
and/or oxygen rich systems and should not be selected as
a sealant for chlorine or other strong oxidizing materials.
For safe handling information on this product, consult the
Material Safety Data Sheet, (MSDS).
ORDERING INFORMATION
Part Number Container Size
34311 5 oz. cartridge
34310 10.1 oz. cartridge
81544 7.5 oz. PowerBead
STORAGE
Product shall be ideally stored in a cool, dry location in
unopened containers at a temperature between 8°C and 28°C
(46°F and 82°F) unless otherwise labeled. Optimal storage is
at the lower half of this temperature range.
DATA RANGES
The data contained herein may be reported as a typical value
and/or range. Values are based on actual test data and are
verified on a periodic basis.
NOTE
The data contained herein are furnished for information only
and are believed to be reliable. We cannot assume
responsibility for the results obtained by others over whose
methods we have no control. Permatex, Inc. specifically
disclaims all warranties expressed or implied, including
warranties of merchantability or fitness for a particular
purpose, arising from sale or use of Permatex, Inc.
products and disclaims any liability for consequential or
incidental damages of any kind, including lost profits.
This product may be covered by one or more United States or
foreign patents or patent applications.