SDS

Material Safety Data Sheet
1. PRODUCT IDENTIFICATION
Product Name: 84209 STEEL WELD (HARDENER)
Item No: PTX203008C
Product Type: Epoxy hardener
2. COMPOSITION/INFORMATION ON INGREDIENTS
Component: Weight% ACGIH; TLV-TWA OSHA PEL
MERCAPTAN AMINE BLEND
TSRN 679485-6533P
_
30-60 Not listed Not listed
LIMESTONE
1317-65-3
30-60 Not listed 15 mg/m
3
CRYSTALLINE SILICA
14808-60-7
0.1-1.0 0.025 mg/m
3
Not listed
3. HAZARDS IDENTIFICATION
Toxicity:
May cause skin burns and corneal injury resulting in permanent impairment of vision including blindness .
Causes severe respiratory irritation . May cause gastrointestinal irritation. May cause skin sensitization.
Primary Routes of Entry:
Eye and skin contact, ingestion, inhalation
Signs and Symptoms of Exposure:
Eye irritation may be severe and result in injury. Contact causes severe skin irritation and possible burns.
Can burn mouth, throat, and stomach. Repeated skin contact may cause allergic skin reactions.
Component: Weight% NTP ACGIH Carcinogens IARC Carcinogen
CRYSTALLINE SILICA
14808-60-7
0.1-1.0 A2 - Suspected
Human Carcinogen
Group 1 Monograph 68, 1997
(inhalation of quartz)
Aggravated Medical Condition:
Preexisting eye, skin and respiratory disorders may be aggravated by overexposure to this product.
4. FIRST AID MEASURES
Ingestion:
If swallowed, do not induce vomiting - seek medical advice. Never give anything by mouth to an
unconscious person.
Inhalation:
Move to fresh air in case of accidental inhalation of vapours. Oxygen or artificial respiration if needed.
Seek immediate medical attention.
Skin Contact:
Immediately remove contaminated clothing and excess contaminant. Flush with water for at least 15
minutes. Wash thoroughly with soap and water. Consult a physician if irritation develops.
Eye Contact:
Rinse immediately with plenty of water, also under the eyelids, for at least 15 minutes. Immediate medical
attention is required.
5. FIRE FIGHTING MEASURES
Flash Point °F(C°):
>200°F (>93°C)
Recommended Extinguishing Media:
Dry chemical, Carbon dioxide, Foam
Special Fire-Fighting Procedures:
Firefighters shoud wear self-contained breathing apparatus and protective
clothing to prevent all skin and eye contact
Hazardous Products of Combustion:
Oxides of carbon, Oxides of nitrogen, Oxides of sulfur
Unusual Fire/Explosion Hazards:
Irritating or toxic gases or fumes may be generated by thermal
decomposition or combustion.
Lower Explosive Limit:
n/d
Upper Explosive Limit:
n/d
6. ACCIDENTAL RELEASE MEASURES
Spill Procedures:
Maintain good ventilation. Take up with an inert absorbent. Store in a closed waste container until disposal.
Wear appropriate protective and respiratory equipment.
1 of 3
ITW Permatex
10 Columbus Blvd.
Hartford, CT 06106 USA
Telephone: 1-87-Permatex
[phone]
Emergency: 800-255-3924 (ChemTel)
International Emergency: 00+ 1+ 813-248-0585