SDS

4. FIRST AID MEASURES
Inhalation:
Move to fresh air in case of accidental inhalation of vapours. Obtain medical attention.
Skin Contact:
Remove contaminated clothing. Wash area with soap and water. If irritation persists, seek medical
attention
Eye Contact:
In case of contact, immediately flush eyes with plenty of water for at least 15 minutes and get medical
attention if irritation persists
5. FIRE FIGHTING MEASURES
Flash Point °F(C°):
52.7°F (11.5°C)
Recommended Extinguishing Media:
Carbon dioxide, Dry chemical, Foam
Special Fire-Fighting Procedures:
Firefighters shoud wear self-contained breathing apparatus and protective
clothing to prevent all skin and eye contact
Hazardous Products of Combustion:
Oxides of carbon, Oxides of nitrogen
Unusual Fire/Explosion Hazards:
Flammable. Closed containers may rupture or explode when exposed to
extreme heat. Keep containers cool.
Lower Explosive Limit:
1.6%
Upper Explosive Limit:
12.5%
6. ACCIDENTAL RELEASE MEASURES
Spill Procedures:
Eliminate all sources of ignition. Maintain good ventilation. Take up with an inert absorbent. Store in a
closed waste container until disposal. Prevent from entering waterways or sewers.
7. HANDLING AND STORAGE
Storage:
Store away from heat, sparks or open flame. Do not store at temperatures above 100°F (38°C).
Handling:
Do not use near heat, sparks or open flame. Do not inhale vapors. Avoid contact with skin and eyes. Wash
thoroughly after handling.
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Eyes:
Safety glasses.
Skin:
Neoprene or nitrile gloves recommended. Wash contaminated clothing before re-use.
Ventilation:
Where reasonably practicable this should be achieved by the use of local exhaust ventilation and good
general extraction.
Respiratory Protection:
An approved organic vapor respirator should be worn when exposures are expected to exceed the
applicable limits.
9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance:
White viscous liquid
Odor:
Solvent
Boiling Point:
213°F (100.5°C)
pH:
Not applicable
Solubility in Water:
Slight
Specific Gravity:
0.95
VOC(Wt.%):
<50 g/L
Vapor Pressure:
28 mmHg @ 68°F
Vapor Density (Air=1):
>1
Evaporation Rate:
>1 (butyl acetate = 1)
10. STABILITY AND REACTIVITY
Chemical Stability:
Stable
Hazardous Polymerization:
Will not occur
Incompatabilities:
Strong oxidizers, Reducing agents
Conditions to Avoid:
Keep away from heat, sparks and open flame
Hazardous Products of Combustion:
Oxides of carbon, Oxides of nitrogen
11. TOXICOLOGICAL INFORMATION
See Section 3
12. ECOLOGICAL INFORMATION
No data available
Item No. R478ADH2
84115 5 MINUTE PLASTIC WELD
(ADHESIVE)
Product Name: