SDS

6. ACCIDENTAL RELEASE MEASURES
Spill Procedures:
Wipe or scrape up spill material. Maintain good ventilation for large spills. Place scrap material in a well-
ventilated area and allow to cure to rubber. Clean up spills thoroughly as residue is slippery.
7. HANDLING AND STORAGE
Storage:
Keep containers tightly closed in a cool, well-ventilated place. Store away from water or moisture.
Handling:
Avoid contact with skin and eyes. Do not wear contact lenses. Wash thoroughly after handling. Product
may cause surfaces to become slippery.
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Eyes:
Safety glasses.
Skin:
Neoprene or nitrile gloves recommended.
Ventilation:
Where reasonably practicable this should be achieved by the use of local exhaust ventilation and good
general extraction.
Respiratory Protection:
An approved organic vapor respirator should be worn when exposures are expected to exceed the
applicable limits.
Comments:
When heated to temperatures above 300 degrees F. in the presence of air, this product can form
formaldehyde vapors. Formaldehyde is a potential cancer hazard and a known skin and respiratory
sensitizer. Safe handling conditions may be maintained by keeping vapor concentrations below the OSHA
permissible limit for formaldehyde
9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance:
Blue paste
Odor:
Mild
Boiling Point:
Not applicable, polymeric material
pH:
Does not apply
Solubility in Water:
Polymerized
Specific Gravity:
1.44
VOC(Wt.%):
3.1%, 44.75 g/l
Vapor Pressure:
<5 mm Hg @ 80°F
Vapor Density (Air=1):
3.0
Evaporation Rate:
Not Determined
10. STABILITY AND REACTIVITY
Chemical Stability:
Stable at normal conditions
Hazardous Polymerization:
Will not occur
Incompatabilities:
Polymerized by contact with moisture, Strong oxidizers, Acids, Iron
Conditions to Avoid:
Exposure to moisture
Hazardous Products of Combustion:
Oxides of carbon, Oxides of nitrogen, Methyl ethyl ketone, possibly methyl
ethyl ketoxime, Silica fume, Formaldehyde
11. TOXICOLOGICAL INFORMATION
See Section 3
12. ECOLOGICAL INFORMATION
No data available
13. DISPOSAL CONSIDERATIONS
Recommended Method of Disposal:
Disposal should be made in accordance with federal, state and local regulations.
US EPA Waste Number:
NH - Not a RCRA Hazardous Waste Material
14. TRANSPORTATION INFORMATION
DOT (49CFR 172)
U.S. Department of Transportation - DOT - 49 CFR (Ground)
DOT Shipping Name:
Not regulated
Hazard Class:
None
UN/ID Number:
None
IATA (Air)
Proper Shipping Name:
Not regulated
Class or Division:
None
UN/ID Number:
None
ULTRA BLUE GASKET MAKER 13 OZ.
Product Name:
Item No. 81725