Specification Sheet
Toll Free: 87 PERMATEX
(877-376-2839)
10 Columbus Blvd., Hartford,
Connecticut 06106
6875 Parkland Boulevard, Solon
Ohio 44139
Technical Data Sheet
Permatex
Gasket Remover
AAM Revised 03/08
NOT FOR PRODUCT SPECIFICATIONS.
THE TECHNICAL DATA CONTAINED HEREIN ARE INTENDED AS REFERENCE ONLY.
PLEASE CONTACT PERMATEX, INC., TECHNICAL SERVICE DEPARTMENT FOR ASSISTANCE AND RECOMMENDATIONS FOR YOUR SPECIFIC APPLICATION.
PERMATEX, INC., HARTFORD SQUARE NORTH, 10 COLUMBUS BOULEVARD, HARTFORD, CT 06106 PHONE – (1-87PERMATEX)
Permatex is a trademark of Illinois Tool Works, Inc. 2008 ITW Permatex, Inc. All rights reserved.
PRODUCT DESCRIPTION
Permatex
Gasket Remover is an aerosol product designed to
remove gaskets and gasket residue from any type of metal or
plastic housing. The product will also remove chemical
formed-in-place gaskets. The Permatex
Gasket Remover is
a safe alternative to the harsh, chlorinated and brominated
solvents found in many of today’s standard gasket removing
chemicals.
NOTE: This product is not recommended for use on silicone
gasket residue.
PRODUCT BENEFITS
A safe alternative to chlorinated and brominated solvents
Non-chlorinated, non-brominated
Built in brush top to easily apply to gasket reidues
Penetrates and cleans intricate shapes
Will not run, even on vertical surfaces
Eliminates excessive scraping and potential damage to
flanged surfaces
Saves time and labor
TYPICAL APPLICATIONS
Removes baked-on gaskets and gasket cements
Removes formed-in-place gaskets
Removes gaskets from aluminum without scraping
Removes gaskets from small, difficult to reach areas
DIRECTIONS FOR USE
1.
Provide adequate ventilation.
2.
Protect painted and non-metal surfaces from overspray.
The product will remove paint.
3.
Shake can well. For best results, the aerosol can
should be at room temperature before spraying.
4.
Apply Gasket Remover by depressing pad to angle
brush. Using brush, spread Gasket remover over
gasket residue.
5.
Allow to set for at least 15 minutes (for anaerobic
gaskets, allow to set for 20 to 30 minutes). Remove
dissolved gasket with a plastic scraper and rags. Re-
apply if necessary.
6.
Prep flange for new gasket by cleaning with Permatex
Brake and Parts Cleaner.
For Cleanup
1.
Clean hands with Permatex
brand hand cleaners.
PROPERTIES OF MATERIAL
Typical Value
Chemical Type
Di-basic esters
Appearance
White foam
Odor
Slight solvent
Specific Gravity
1.07
Flash Point, PMCC ºF
>200
GENERAL INFORMATION
This product is not recommended for use in pure oxygen
and/or oxygen rich systems.
For safe handling information on this product, consult the
Material Safety Data Sheet, (MSDS).
ORDERING INFORMATION
Part Number
Container Size
80645
4 oz. aerosol, carded
STORAGE
Products shall be ideally stored in a cool, dry location in
unopened containers at a temperature between 8 and 28C
(46 and 82F) unless otherwise labeled. Optimal storage is at
the lower half of this temperature range.
NOTE
The data contained herein are furnished for information only
and are believed to be reliable. We cannot assume
responsibility for the results obtained by others over whose
methods we have no control. ITW Permatex, Inc.
specifically disclaims all warranties expressed or implied,
including warranties of merchantability or fitness for a
particular purpose, arising from sale or use of Permatex,
Inc. products and disclaims any liability for consequential
or incidental damages of any kind, including lost profits.
This product may be covered by one or more United States or
foreign patents or patent applications.