SDS

5. FIRE FIGHTING MEASURES
Flash Point °F(C°):
<0° F
Recommended Extinguishing Media:
Carbon dioxide, Dry chemical, Foam
Special Fire-Fighting Procedures:
Firefighters should wear self-contained breathing apparatus. Water spray
may be ineffective on flames but should be used to keep fire-exposed
containers cool.
Hazardous Products of Combustion:
Oxides of carbon
Unusual Fire/Explosion Hazards:
Keep containers cool. Closed containers may rupture or explode when
exposed to extreme heat. Vapors may travel from container toward sources
of ignition and flashback.
Lower Explosive Limit:
0.9%
Upper Explosive Limit:
13.0%
6. ACCIDENTAL RELEASE MEASURES
Spill Procedures:
Eliminate all sources of ignition. Maintain good ventilation. Take up with an inert absorbent. Store in a
closed waste container until disposal. Prevent from entering waterways or sewers.
7. HANDLING AND STORAGE
Storage:
Store away from heat, sparks or open flame. Do not store at temperatures above 100°F (38°C). Exposure
to high temperatures may cause container to burst.
Handling:
Avoid contact with skin and eyes. Avoid breathing vapors, if exposed to high vapor concentration, leave
area at once. Do not use near heat, sparks or open flame. Vapors may accumulate readily and may ignite
explosively. Wash thoroughly after handling. Keep container closed when not in use.
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Eyes:
Safety glasses.
Skin:
Neoprene or nitrile gloves recommended. Wash contaminated clothing before re-use.
Ventilation:
General; local exhaust ventilation as necessary to control any air contaminants to within their exposure
limits (or to the lowest feasible levels when limits have not been established) during the use of this
product.
Respiratory Protection:
An approved organic vapor respirator should be worn when exposures are expected to exceed the
applicable limits.
9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance:
Clear viscous liquid
Odor:
Solvent
Boiling Point:
133°F
pH:
Does not apply
Solubility in Water:
Nil
Specific Gravity:
0.79
VOC(Wt.%):
60.6%
Vapor Pressure:
Not determined
Vapor Density (Air=1):
>1
Evaporation Rate:
>1 (butyl acetate = 1)
10. STABILITY AND REACTIVITY
Chemical Stability:
Stable at normal conditions
Hazardous Polymerization:
Will not occur.
Incompatabilities:
Avoid contact with bases and strong oxidizers, Acids
Conditions to Avoid:
Keep away from heat,sparks and flame.
Hazardous Products of Combustion:
Oxides of carbon
11. TOXICOLOGICAL INFORMATION
See Section 3
12. ECOLOGICAL INFORMATION
No data available
2 of 3
CONTACT CEMENT 1.5 OZ TB/CG
Product Name:
Item No: 25905