Warranty
Table Of Contents
- Warning
- ASSEMBLY INSTRUCTIONS
- Installation Hardware:
- INSTALLATION INSTRUCTIONS
- CLEANING AND MAINTENANCE
- Troubleshooting:
- A) When heater will not turn on:
- 1. Check if the power cord is plugged into an electrical outlet, if not, plug it in.
- 2. Make sure power outlet has power running through it.
- B) LED light is on but no heat.
- Limited Warranty:
- Limitation of Remedies and Liability:
6. Attach heater unit to wall brackets (Note: two people are needed for this step) while one person
holds & aligns the heater unit to mounting brackets, the 2nd person should use the two (E) nuts
M6mm and two (F) M6mm* 12mm Hex Bolts to attach to wall brackets. Please install the bolts from
the inside and tighten the bolt nuts from the outside to secure the brackets and adjust brackets if
necessary. (see Figure E).
The heater must be installed at least 6 feet above the floor and mounted horizontally.
E
(16 inches)
(6 feet)
(16 inches)
(16 inches)
Mount brackets attached
to heater on the outside
edge of wall mount