Warranty
Table Of Contents
- Warning
- ASSEMBLY INSTRUCTIONS
- Installation Hardware:
- INSTALLATION INSTRUCTIONS
- CLEANING AND MAINTENANCE
- Troubleshooting:
- A) When heater will not turn on:
- 1. Check if the power cord is plugged into an electrical outlet, if not, plug it in.
- 2. Make sure power outlet has power running through it.
- B) LED light is on but no heat.
- Limited Warranty:
- Limitation of Remedies and Liability:
1. Attach 2pcs (A) L brackets to heater unit with 4pcs (D) M5mm*10mm Bolts (see Figure A).
2. D
rill 5/16” diameter holes on wall or celling. (see Figure B) For best results, attach directly on wall
studs if possible.
3. Holes for anchors should be drilled 1 inch apart for each bracket, use bracket as template. The
distance between left & right brackets should be 3-3/8 to 3-1/2 inches center to center of inner
holes of brackets.
A
B
5/16” diameter
Anchor holes
1”
3-3/8” – 3-1/2”
1”