Warranty

Step3:
Locate the following parts: Heating element (A), the tube you assembled in step 2, PM5*10 screw,
PM4*20 screw and the power cord buckle. Thread the power cord attached to the heating element
down the tube, may need to pull the power cord from the bottom.
Once the entire power cord has been pulled through the tube, connect the heating element to the tube
with PM5*10 screw and tighten the screw. Secure the power cord with the cord buckle with PM4*20
bolts.
Note: The heater has a 45℃ tip over angle function. If the heater tips over more than 45-degree angle, the
heater will be automatically shut off.
WARNING: Ensure that the supply cables are well mounted and that it does not come in contact
with the reflector of the heater or that it does not trail into a heated area.
PM4*20 bolts
Power cord buckle
Power cord