Installation Instructions

PERLICK RESIDENTIAL RS-CDK INSTALLATION INSTRUCTIONS
8 | perlick.com/residential
INSTALLATION
Locate the dispensing head , black beer line(s), and hose
clamp(s).Slideoneendofeachbeerlineontothestainless
steeltubeswhichprotrudeouttheboomofthedispensing
headandclampght.
Removetransittapewithaulityknifearoundtheholeinthe
topoftheunitfrombothinsideandoutsideofthecabinet.
Gentlypunchoutfoamw/screwdriverandremove.Insertthe
beerline(s)throughtheholeinthecountertop.Movehead
asideandbeadsiliconearoundperimeterofhole,andthen
posiontheheadbackinplace.Fastenusingthe4chrome
screws included with the dispensing head. Wipe oexcess
siliconetocompletetheseal.
1.
2.
Usethe3/8”-thickfoampadincludedinthetappingkitand
rollintoacylinder.Frominsidethecabinet,insertthefoam
tubeupthroughtheholeinthecountertopunlitisrmly
againsttheinsulaoninthedispensinghead.Mark,thenput
awayanyexcessfoam.
NOTE: If using an Adara tower, foam needs to be installed so
that it is pressed up against the boom mounng ange of
the tower.
3.