Installation Instructions

PERLICK RESIDENTIAL RS-CDK INSTALLATION INSTRUCTIONS

12 | perlick.com/residential

INSTALLATION

CONNECTING THE REGULATOR TO THE NITROGEN CYLINDER

1. Removetheblueplugfromtheregulatorng,butdonot

removethecarbonicwasher.

2. Screwregulatorontogascylindervalve.Tightenwithwrench

unlvercallystraight.Besurethattheshut-ovalveonthe

regulatorisintheOFF(horizontal)posion.

3. Placescrewclamp overthe end of redlineand push onto

regulatortailpiece.Tightenclampwithascrewdriver.

4. Turnregulatoradjusngscrewcounterclockwiseunlitturns

freely.

5. Turnhandvalvecounter-clockwiseonthenitrogencylinder

tothefullyopenposion.

6. Turn regulator adjusng screw clockwise unl desired

pressureisreached(approximately12-15lbs.)Tightenstop

nutonadjusngscrew.

7. Openshut-outvalveonboomofregulator.

8. Dilute a small amount of liquid dishwashing soap and rub

the soapy mixture around connecons. If bubbles appear,

ghtenconnecon.

NITROGEN