User's Manual

Form No. Z2283
Rev. 06.14.10
Installation and Operating Instructions
Sizes and Specifications, Concessionaire Dispensers
2
Perlick is committed to continuous improvement. Therefore, we reserve the right to change specifications without prior notice.
MODEL NOS. DC72S DC84S DC96S
KEG CAPACITY 2 Keg 3 Keg 4 Keg
CABINET Length Ins. (mm) 72” (1829) 84” (2134) 96” (2438)
DIMENSIONS Depth Ins. (mm) 24
3
/
4
” (629) 24
3
/
4
” (629) 24
3
/
4
” (629)
w/o BUMPERS Height Ins. (mm) 34
1
/
2
” (876) 34
1
/
2
” (876) 34
1
/
2
” (876)
NO. OF DISPENSING HEADS 1 1 2
NO. FAUCETS 2 2 2
CONDENSER UNIT H.P.
1
/
4
1
/
3
1
/
3
RUNNING LOAD - AMPS 5.9 7.5 7.5
SHIP WT lbs. (kg) 445 (202) 505 (229) 545 (247)
INTERIOR
Door sill: High strength polyethylene. Door pan and ceiling: High strength polystyrene.
Floor pan: Satinless steel. Walls: Galvanized steel.
EXTERIOR
All Models: The top is stainless steel. The back, front and sides are stainless steel. Bottom is
galvanized steel. Doors and grilles are stainless steel.
REFRIGERATION
R-134a capillary tube-type. Aluminum fin and copper tube evaporator, epoxy coated coil. Forced air
into dispensing head. Adjustable temperature control. Self-defrosting. Pull-out condensing unit for
service and cleaning.
VENTILATION Front ventilated.
ELECTRICAL 115 Volt, 60 Hz., 1 Phase AC. Furnished with three prong, six foot NEMA5-15P cord.
Contact Perlick for other voltage/frequency requirements.
PLUMBING
Evaporator condensate has been plumbed to a condensate pan located in the compressor housing.
INSULATION Foamed-in-place polyurethane; 2” walls, 1
1
/
2
” top and floor.
OPTIONAL ACCESSORIES • Keg Couplers • Faucet Locks
• Regulators • Optional Dispensing Heads
TopView
End View
NOTE: This equipment is intended for the storage and display
of non-potentially-hazardous bottled or canned products only.