User Guide

© 2008
2
24" C-Series Operation / Installation Manual
GENERAL PRECAUTIONS
DANGER
Risk of child entrapment. Before you throw away your old
refrigerator or freezer, take off the doors and leave shelves in
place so children may not easily climb inside.
DANGER
Altering or cutting of the power cord, or removal of the power
plug, or direct wiring can cause serious injury, fire and/or loss
of property and/or life and will void the warranty.
WARNING
• Never attempt to repair or perform maintenance on the
unit until the electricity has been disconnected.
• The anti-tip kit must be installed on this unit before it is
used. Never use the shelves or doors as steps or to sup-
port more than they are designed to support.
CAUTION
• Do not lift unit by shelves or door handle.
• Failure to clean the condenser every three months can
cause the unit to malfunction. This could void the warranty.
• Never install the unit behind closed doors. Be sure front
louvered toe plate is free of obstruction. Obstructing free
air flow can cause unit to malfunction and may void the
warranty.
CAUTION
Use only Perlick replacement parts. Imitation parts can dam-
age the unit, and may void the warranty.
INSTALLATION SPECIFICATIONS
General
• All electrical instructions assume that outlet is located 4-10 inches
from the floor.
• Floor must be level in area of installation. Leg levelers are used for
fine-tune adjustment only and should not be used to compensate for
floor differences exceeding 1/2".
• When moving unit into position, take care to protect floor surface with
cardboard, rugs, etc.
50” area in which
electrical outlet must be located
13
1
/16” distance
same on both sides of cabinet
4
1
/2” min.
clearance to side wall
on corner installation
24
25
/32” door swing clearance
98° min. door swing
for pull-out shelf
clearance
25
27
/64”
23
15
/16”
22
1
/8”
3
39
/64”
1
53
/64”
23
7
/8”
34
5
/16””
• Never attempt to move unit without the aid of at least one other per-
son.
• Always secure doors shut prior to moving the unit.
Finished Rough Opening Requirements
• Height: 34-1/2"
• Depth: 24"
• Width: 24"
Figure 1. Dimensions