Install Guide

Form No. Z2334A
3
Drain Pump Kit for Undercounter Clear Ice Makers
For use with H50IMS, H50IMW and H50IMS-AD Clear Ice Makers
5. Carefully place the drain pump into the open space
provided at the rear of the icemaker. The drain pump will
overhang the base slightly. (See Fig. 4). If necessary, care-
fully bend or move the icemaker’s copper tubing so that
it does not make contact with the drain pump, hoses, or
other parts of the icemaker.. CAUTION! Drain pump MUST
be level.
6. Connect the drain hose/drain elbow to the drain pump as
illustrated (see Fig. 4). Secure the drain hose/drain elbow
with the remaining large clamp provided in this kit.
CAUTION! Do not over-tighten the clamp.
7. Remove the jumper plug from the icemaker’s drain pump
connector. (See Fig. 5). The jumper plug is not needed when
a drain pump is installed.
8. Connect the drain pump plug to the icemaker’s drain
pump connector.
Continued on page 4
Fig. 4
Fig. 5