Install Guide

2
Form No. Z2334A
Drain Pump Kit for Undercounter Clear Ice Makers
For use with H50IMS, H50IMW and H50IMS-AD Clear Ice Makers
INSTALLATION INSTRUCTIONS
This drain pump is designed to remove drain water from an
undercounter icemaker in areas without direct drainage access.
The drain pump reservoir collects drain water and pumps it
through a 1/2” ID high pressure clear pvc hose (discharge hose).
The maximum discharge hose length is 20 feet. The maximum
lift height is 8 feet. There is a factory installed check valve on the
drain pump.
NOTICE! Do not install any additional check valves.
1. Move the control switch to the “OFF” position and unplug
the unit from the electrical outlet.
2. Remove the rear access panel and rear cover (see Fig. 1).
Disconnect the drain house and remove the rear drain
bracket and drain tting.
3. If the sheet metal tabs are present on your unit, remove
them (see Fig. 2).
4. Remove the original drain hose and install the new drain
hose (5/8” ID×6.5”) provided in this kit (see Fig. 3). On -AD,
cut the new drain hose to a length of 5”. Secure the new
drain hose with one of the large clamps provided in this kit.
CAUTION! Do not over-tighten the clamp.
Fig. 1
Fig. 2
Fig. 3