Datasheet

Perle 10/100 Ethernet Media Converter – Installation Guide
9
Installing the Duplex Fiber Cable
• Locate a 100Base-X compliant duplex (2 strands) fiber cable with
appropriate connectors.
• Connect the fiber cables from one media converter to the other
media converter/switch/fiber device ensuring that the RX and TX
are reversed (crossed) at the opposite end.
Installing the Simplex Fiber Cable
• Locate a 10/100Base-X compliant simplex (1 strand) fiber
cable with appropriate connectors.
• Connect the fiber cable from one media converter to the other
media converter/switch/fiber device.
Installing the Copper Cable
• Locate 10/100Base-T compliant copper cables with male, RJ-
45 connectors installed at both ends.
• Connect the RJ-45 cable between the Perle media converter
and the device.
NOTE: The S-110 supports Auto-MDIX which allows a straight-
through or cross-over Ethernet cable. See page three in this
guide for jumper positions.