Datasheet

Perle 10/100 Ethernet Media Converter – Installation Guide
8
Duplex (fiber) (Switch 6)
Switch Position Mode
Up (default) Full
Down Half
Full: The media converter’s fiber link will be set to Full Duplex
Mode.
Half: The media converter’s fiber will be set to Half Duplex Mode.
Loopback (Switch 7)
Switch Position Mode
Up (default) Disabled
Down Enabled
Disabled: The loopback feature is disabled. This is default
position for normal operation. The switch must be set to this
position in order for data to pass through the media converter.
Enabled: This is a test mode. All data received on the receive
(RX) fiber connection is looped back to the transmit (TX) fiber
connection. The state of the copper link is not relevant since no
data is passed through to the copper side. This mode will
override all other switch settings.