Datasheet

Perle 10/100 Ethernet Media Converter – Installation Guide
10
Powering up the Perle Media Converter
• Connect the Perle supplied power adapter to the media
converter.
• Connect the power adapter to a power source.
• Check that the PWR LED light is lit.
Extended Temperature models supplied with a Terminal
Block
• Ensure the Power Source is off prior to connection.
• Strip both wires 5mm (3/16
th
inch)
• Loosen the terminal block screws and connect Positive (+)
wire to the left terminal. Connect the Negative (-) wire to the
right terminal. Tighten Terminal screws (0.22Nm-0.25Nm
torque).
• Turn on power source.
• Check that the PWR LED light is lit.
• For extra power cable strain relief, attach the strain clip to the
case as shown below, and thread the power cable through the
clip in either one or two loops.