User Guide

ManualsBrandsperle ManualsCellular Routerperle IRG7440 5G Cellular Router

IRG7440 5G Cellular Router Quick Start Guide 5500480

Version #A01.13.2022

IRG7440 5G Cellular Router

Quick Start Guide

_____________________________________

This guide covers the basic installation and configuration of

the IRG7440 5G Cellular Router and is intended for first-

time setup or product evaluation.

Complete details can be found in the following guides at

www.perle.com/downloads

• IRG7440 5G Cellular Router Hardware Installation

Guide

• IRG7000/5000 5G/LTE Router User’s Guide

• IRG7000/5000 5G/LTE Router Command Line Interface

Reference Guide

What’s in the box?

The following components may be included with your

product. Components will vary depending on each model.

See the Perle website for updates

• IRG7440 5G Cellular Router

• IRG7440 5G Cellular Router Quick Start Guide (this

guide)

• 5G/LTE SMA antenna pack-4 (#08000530)

• GPIO Cable with 4 pin plug (#2500468)

• GPIO Cable with 8 pin plug (#2500476)

Summary of content (4 pages)

PAGE 1
IRG7440 5G Cellular Router Quick Start Guide _____________________________________ This guide covers the basic installation and configuration of the IRG7440 5G Cellular Router and is intended for firsttime setup or product evaluation. Complete details can be found in the following guides at www.perle.com/downloads.
PAGE 2
• • • 12VDC/2A 4 pin (NA#08000150, EU #08000160, UK #08000170, AUS#08000180) Orderable–GNSS PAV RP Antenna SMA/CA (#08000130) passive Orderable–DIN Rail mounting kit (orderable from Perle) Getting Started Typical installation steps are: 1. Inserting the SIM card. 2. Connecting 5G/LTE antenna/s. 3. Connecting the Power. 4. Connecting to the Cellular Network. 5. Fast Setup Mode. Inserting the SIM card Use only a mini-SIM (2FF) card. Ensure the power is disconnected before you insert the SIM card. 1.
PAGE 3
Connecting the 5G/LTE Antennas 1. Connect an antenna to the connector Main. 2. Connect an antenna to the connector MIM01. 3. Connect an antenna to the connector MIM02. 4. Connect an antenna to the connector DIV/GNSS L1. See Figure 2 Connecting the Power See Figure 2 for wiring requirements. The colors indicated are for the Perle supplied DC cable. Connecting to the Cellular Network When the router is powered on, it begins activating and attempting to connect to the cellular network.
PAGE 4
Fast Setup Mode Fast Setup provides a simple method of doing an initial setup from a PC. Your router is shipped in factory default mode. 1. 2. 3. 4. 5. Your PC must be set to obtain an IP address automatically using DHCP. Plug the PC into your router’s Ethernet interface. When the Power LED is flashing green, use a web browser, enter http://192.168.0.1 to access your router. On the setup screen, select, Getting Started. Once connected, fill in the required fields, apply changes to save and exit.