Installation guide

IDS-108F installation Guide

Mounting the IDS-108F on a DIN-rail

1. The DIN-rail clip will be fixed to the back panel of the IDS-

108F switch when you receive the product.

2. Position the IDS-108F such that the top of the DIN rail fits into

the slot on the top of the DIN-rail clip, just below the DIN-rail

hook and behind the spring.

3. While pushing down on the unit to compress the spring, rotate

the bottom of the IDS-108F toward the rail. This will snap the

bottom of the rail into the bottom of the clip. See diagram

below.

Note: To remove the IDS-108F from the DIN-rail, push down slightly on the

IDS-108F unit while pulling the bottom out.