Installation guide

IDS-105G Installation Guide - 15 -

Ethernet Copper Cabling Requirements

• Category 5 UTP or STP

• 24-22 AWG

• Straight through or Ethernet crossover cable

Connect the copper cables from each TP port (RJ-45) on the IDS-

105G switch to Ethernet-enabled devices. See below for pinouts.

8-pin RJ-45

Remaining pins not used.

Fiber Port Cabling Requirements

MM: 50/125 microns or 62.5/125 microns

SM: 9/125 microns

Connect the fiber cables to Port 6/7 on the IDS-105G and the

other end to a compliant fiber devices. If you are making your own

fiber cables, remember that the RX on one side needs to go to TX

on the other side and vice versa. See diagram below.