Remote I/O System User Guide

RIO Remote I/O System User Guide

Installing RIO under SCO UnixWare

Page 77

Chapter 2 Installing hardware and software

General installation procedure for SCO UnixWare

The general procedure for installing and configuring host cards, Remote Terminal Adaptors

drivers software and associated utilities for the SCO UnixWare operating system is as

follows:

1. If required, install any PCI host cards you require into your system. See Installing a

Universal 3.3/5V PCI host card on page 156.

2. If required, install the RIO SCO UnixWare drivers and utilities onto your system using the

procedures described in Installing device drivers and utilities on page 78.

3. If required, install any ISA host cards you require into your system. See Installing an ISA

host card on page 158.

4. If required, remove any host cards you want from your system. See Removing host

cards on page 160.

5. Install or remove any Remote Terminal Adaptors you require onto your system. See

Installing Remote Terminal Adaptors (RTAs) on page 161 and Removing a Remote

Terminal Adaptor (RTA) on page 173.

6. Add any Remote Terminal Adaptors to your system configuration and setup as required

using the procedures given in Adding an RTA to the system on page 83.

7. Remove any Remote Terminal Adaptors from your system configuration as required

using the procedures given in Removing an RTA from the system on page 86.

Your system is now ready for use. If you add any RTAs to your system following initial

installation you need to can create logins for them using the procedures given in Creating a

Note

To remove the RIO device drivers and utilities from your system, see Removing

device drivers and utilities from your system on page 89.