Remote I/O System User Guide

RIO Remote I/O System User Guide
Installing RIO under SCO OpenServer 5 and SCO OpenServer 6
Page 69
Chapter 2 Installing hardware and software
Removing an RTA from the system
To remove an RTA from your system configuration, proceed as follows;
1. Physically remove the Remote Terminal Adaptor from your system using the procedures
detailed in Removing a Remote Terminal Adaptor (RTA) on page 173.
2. Login to your system as super user.
3. At the command prompt, type config.rio and press the Enter key.
The RIO configuration utility window is now displayed.
4. Press the Enter key.
The Main Menu is now displayed.
5. In the Main menu, click on Delete an RTA.