Remote I/O System User Guide

RIO Remote I/O System User Guide
Installing RIO under SCO OpenServer 5 and SCO OpenServer 6
Page 67
Chapter 2 Installing hardware and software
9. If required, check your configuration settings as follows; In the RTA Management menu,
click on View RTA settings.
The RTA Settings window is now displayed as shown in the next picture.
10.If you are happy with the configuration settings press the ESC key to close the window.
Otherwise, repeat step 4. onwards of this procedure to change the configuration as
required.
11.Press the Esc key twice
A prompt window is now displayed asking you if you want to save changes before exiting
config.rio.
Note
The changes you have made to the system configuration will not take
effect until you exit the config.rio utility.