Remote I/O System User Guide

RIO Remote I/O System User Guide
Installing RIO under SCO OpenServer 5 and SCO OpenServer 6
Page 65
Chapter 2 Installing hardware and software
Adding an RTA to the system
To add an RTA to your system configuration, proceed as follows;
1. Physically install the Remote Terminal Adaptor in your system using the procedures
detailed in Installing Remote Terminal Adaptors (RTAs) on page 161.
2. Login to your system as super user.
3. At the command prompt, type config.rio and press the Enter key.
The RIO configuration utility window is now displayed showing a map of your system. See
Configuring ports with config.rio on page 64 for more details about how config.rio
works.
4. In the RIO configuration utility window, highlight the unconfigured RTA you want to add to
the system.
Note
The way in which an unconfigured RTA is displayed depends on the types of
terminal being used. Normally, either the RTA icon flashes or appears in a
different colour.