user manual

Installing Protocol Transparent Media

Converter Modules

Caution: Observe electrostatic discharge precautions when

installing the Protocol Transparent Media Converter module(s) into

the chassis. Failure to observe this caution could result in damage

to the module(s) and/or chassis.

The Protocol Transparent Media Converter module(s) can be

installed in any available slot and in any order within the MCR1900

chassis.

1. Remove the module from its packaging.

2. Using a cross-head screwdriver, remove the screw holding the

face plate to the chassis to reveal the slot opening.

3. Set the jumper and DIP switches on the module to the

desired operating mode. (optional)

4. Locate the top and bottom alignment guides inside the MCR

chassis.

5. Using the module alignment guides gently slide the module

into the slot until it becomes flush with the front of the chassis.

Light pressure may be needed to seat the module. Do not

force the module as you might cause damage. If there is

resistance, remove the module and check the module

connector for damaged or incorrectly aligned pins. If these are

not damaged, retry module insertion.

6. Tighten the captive retainer screw to ensure the module is

locked in place.

7. Remove the dust cap from the fiber connectors.