User's Guide

SPEED Serial Adaptors User guide
Installing under Windows NT
Page 57
Chapter 2 Installing drivers and host cards
Installing under Windows NT
The procedure for installing and configuring host cards, drivers software and associated
utilities for the Windows NT operating system is as follows:
1. Install any PCI host cards you require into your system. See Installing a PCI host
card on page 69
2. If required, remove any host cards you want from your system. See Removing host
cards on page 70.
3. Use the PortDirector software to update your system with the revised number and type of
host cards. See The PortDirector user guide part number 5500028 for further details.
Your system can now use the serial adaptor cards you have installed.
Note
The Perle PortDirector software contains drivers for the SPEED host cards.
You will need to install the PortDirector for WIndows NT on your system in order to use
the SPEED host cards.
See Chapter 5 Adding and deleting host cards in the PortDirector User guide
part number 5500028 for further details.