User's Guide

SPEED Serial Adaptors User guide
Installing under SCO UnixWare
Page 39
Chapter 2 Installing drivers and host cards
7. In the Add Local Mount Configuration window, click on OK to accept the settings and
close the window.
The Filesystem Manager window is now updated to show the new mount as shown in the
next picture.
8. Filesystem Manager menu, click on Host > Exit to close the window.
9. At the command prompt, type:
pkgadd -d /cdrom/drivers/speed/unixware/spd.pkg spd
10.Press the Enter key.
The system now installs the driver and displays a series of messages ending with a
successful installation message.
Upon installation of the drivers, your SPEED cards are ready to use.
Note
A re-boot of your system is not necessary as the drivers for your SPEED card are
dynamically loadable and will be loaded as soon as any software attempts to access the
associated devices.