User's Guide

SPEED Serial Adaptors User guide
Installing under SCO OpenServer
Page 21
Chapter 2 Installing drivers and host cards
General installation procedure for SCO OpenServer
The general procedure for installing and configuring host cards, drivers software and
associated utilities for the SCO OpenServer operating system is as follows:
1. Install any PCI host cards you require into your system. See Installing a PCI host
card on page 69
2. Install the SPEED SCO OpenServer drivers and utilities onto your system using the
procedures described in Installing device drivers and utilities on page 22.
3. If required, remove any host cards you want from your system. See Removing host
cards on page 70.
4. Using the Port Configuration tool, configure the serial ports you have added to the
system. See Configuring SPEED serial ports on page 28.
Your system can now use the serial adaptor cards you have installed. If required, you can
reconfigure serial ports following initial installation.