User's Guide

SPEED Serial Adaptors User guide
SCO UnixWare/SCO OpenServer 6
Page 100
SCO UnixWare/SCO OpenServer 6
There are no messages displayed on the system at startup. Messages from the SPEED
driver are sent to the syslog file in the /var/adm directory. Each entry in the syslog file is
date and time stamped (You can review the content of the syslog file using a suitable text
editor). Each time the driver is loaded, entries similar to those shown below indicate
successful SPEED card detection.
Apr 26 16:05:15 pwredge3 unix: Speed Unixware Driver v1.0.0 Apr 26 2000 15:56:35
Apr 26 16:05:15 pwredge3 unix: Copyright (c) 2000 Perle Systems Ltd
Apr 26 16:05:15 pwredge3 unix: unit:0 - Speed4 card @0xFDFF9000 using IRQ:10 - OK
Apr 26 16:05:15 pwredge3 unix: unit:1 - Speed4+ card @0xFDFFD000 using IRQ:15 - OK
Apr 26 16:05:15 pwredge3 unix: Total Speed Ports : 8
Apr 26 16:05:15 pwredge3 unix: unit:1 - Speed4+ card @0xFDFFD000 using IRQ:15 - OK
Driver software version
Total number of SPEED ports
Driver message - always displayed if installed and configured
Host card type
Host card base address in hexidecimal
Host card ID number
IRQ level